| About |
|---|
| Mxsten CV Plastomer CV77516 resin is a polyethylene plastomer designed for blown film extrusion that contains no slip and no antiblock additives. Films produced with this resin exhibit a very low seal initiation temperature with a broad hot tack window. Other features of this resin include higher stiffness and high melting point. Application/Uses ?- Blown film ?- Food Packaging&& |
| Product Description | |
|---|---|
| Supplier | Westlake Chemical |
| Generic | 乙烯基辛烯塑料 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Food contact compliance,Low temperature heat sealing |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.910 | g/cm³ | ASTM D4883 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.0 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 25 | µm | |
| tensile strength | |||
| TD, fracture, 25 µ m, blow molded film | 44.1 | MPa | ASTM D882 |
| MD, fracture, 25 µ m, blow molded film | 56.5 | MPa | ASTM D882 |
| Tensile strain | |||
| TD, fracture, 25 µ m, blow molded film | 1100 | % | ASTM D882 |
| MD, fracture, 25 µ m, blow molded film | 750 | % | ASTM D882 |
| Drop hammer impact | |||
| 25 µ m, blow molded film | 1700 | g | ASTM D1709-A |
| Initial sealing temperature | |||
| 25 µ m, blow molded film | 88.0 | ℃ | Internal Method |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 45 °, 25.4 µ m, blow molded film | 60 | ASTM D2457 | |
| Haze | |||
| 25.4 µ m, blow molded film | 7.0 | % | ASTM D1003 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Test run at 23°C (73°F) and 50% relative humidity |
| 3. Seal initiation temperature is the temperature at which 200 g/inch seal strength is achieved. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |