| About |
|---|
| AS172L-01US is a compounded rubber modified polypropylene with good impact and excellent material flow properties. This product is available in Generic Black for full paint applications and in Natural or Pre-Colored for mold-incolo and/or partial paint applications. Key Applications: Bumper Fascias and other Exterior Parts OEM/Customer General Motors&& |
| Product Description | |
|---|---|
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | High impact resistance,High liquidity,Sprayable |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.02 | g/cm³ | ISO 1183/A |
| Melt Flow Rate | |||
| 230℃，2.16kg | 23 | g/10min | ISO 1133 |
| Shrinkage rate | ISO 294-4 | ||
| — | 6.0E-3 | % | ISO 294-4 |
| 82℃，1 hrs | 7.0E-3 | % | ISO 294-4 |
| 121℃，1 hrs | 8.0E-3 | % | ISO 294-4 |
| Ash Content | |||
| 600℃ | 19.0 | % | ISO 3451-1A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 17.0 | MPa | ISO 527-2/50 |
| Bending modulus | |||
| string | 1700 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 45 | kJ/m² | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 50.0 | ℃ | ISO 75-2/A |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Procedure B |
| 3. 48 hrs after molding |
| 4. 0.079 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |