About |
---|
Nemcon™ E-series products are designed for use in ESDA electronic assembly environments. Nemcon™ E PC CB is a carbon black-filled polycarbonate characterized by consistent moldability, recyclability, low outgassing, and good conductivity. Applications Shipping/handling trays for components, IC’s and circuit assemblies Internal components/assemblies&& |
Product Description | |
---|---|
Generic | Polycarbonate |
Material Status | Commercial: Active |
Features | Excellent Processability,Conductive,Renewable resources,Low odor |
Availabilitys | North America |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 1.26 | g/cm³ | ASTM D792 |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Tensile modulus | |||
23℃ | 2780 | MPa | ASTM D638 |
tensile strength | ASTM D638 | ||
Yield, 23 ℃ | 63.0 | MPa | ASTM D638 |
Fracture, 23 ℃ | 62.0 | MPa | ASTM D638 |
Tensile strain | |||
Fracture, 23 ℃ | 14 | % | ASTM D638 |
Bending modulus | |||
23 ℃, 50 mm span | 2800 | MPa | ASTM D790 |
bending strength | |||
Fracture, 23 ℃, 50 mm span | 100 | MPa | ASTM D790 |
IMPACT | Nominal value | Unit | Test method |
---|---|---|---|
Impact strength of cantilever beam notch | |||
23℃ | 56 | J/m | ASTM D256 |
THERMAL | Nominal value | Unit | Test method |
---|---|---|---|
Hot deformation temperature | |||
1.8 MPa, unannealed, 3.2 mm | 130 | ℃ | ASTM D648 |
Electrical performance | Nominal value | Unit | Test method |
---|---|---|---|
Surface resistivity | 3.0E+4 | ohms | ASTM D257 |
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
2. 2.0 in/min |
3. 0.051 in/min |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |