| About |
|---|
| Neoflon® FEP NP-3180 was developed for high-speed extrusion of thin coatings of small wire sizes such as plenum cable insulation. It may also be used for small tubing and injection molding of thin wall parts.&& |
| Product Description | |
|---|---|
| Supplier | Daikin Fluorochemicals |
| Generic | FEP |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 372℃，2.16kg | 35 to 42 | g/10min | ASTM D2116 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | > 18.0 | MPa | ASTM D2116 |
| Tensile strain | |||
| fracture | > 300 | % | ASTM D2116 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 255 to 265 | ℃ | ASTM D2116 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| MIT flexural strength (cycle) | 3000 | ASTM D2176 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. DSC |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |