| About |
|---|
| neogol® 90 C UG is a Thermoplastic Polyolefin Elastomer (TPO (POE)) product. It can be processed by coextrusion or injection molding and is available in Europe. Characteristics include: Copolymer Weather Resistant&& |
| Product Description | |
|---|---|
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Block Copolymer |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，5.0kg | 40 | g/10min | ASTM D1238 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 34.0 | kN/m | ASTM D624 |
| Compression deformation | |||
| 23℃，72 hr | 53 | % | |
| 70℃，22 hr | 78 | % |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 90 | ASTM D2240 | |
| tensile strength | |||
| — | 6.20 | MPa | |
| 100% strain | 3.70 | MPa | |
| 300% strain | 4.20 | MPa | |
| Tensile strain | |||
| fracture | 690 | % | ASTM D638 |
| abrasion resistance | 334 | mm³ | DIN 53516 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 155 to 175 | °C | |
| Barrel middle temperature | 160 to 180 | °C | |
| Barrel front temperature | 160 to 180 | °C | |
| Nozzle temperature | 165 to 190 | °C | |
| Mold temperature | 25 to 40 | °C | |
| Injection speed | 中等偏快 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. With Notch |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |