| About |
|---|
| NHU-PPA Polymer is a high temperature nylon resin (polyamide) with high toughness and excellent frictional resistance. Good melt flow improve the injection molding processibility, chemicals resistant and excellent mechanical strength.&& |
| Product Description | |
|---|---|
| Supplier | NHU |
| Generic | PPA |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good flexibility,Good liquidity,Solvent resistance |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Viscosity number | 70.0 to 90.0 | cm³/g | ISO 307 |
| water content | < 0.35 | % | |
| Ash Content | < 0.50 | % | ISO 3451 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Glass transition temperature | 128 to 138 | ℃ | ISO 11357-2 |
| Melting temperature | 310 to 320 | ℃ | ISO 11357-3 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 120 to 140 | °C | |
| Drying time | 4.0 to 5.0 | hr | |
| Barrel rear temperature | 315 to 325 | °C | |
| Barrel middle temperature | 320 to 330 | °C | |
| Barrel front temperature | 325 to 335 | °C | |
| Nozzle temperature | 325 to 335 | °C | |
| Mold temperature | 130 to 140 | °C | |
| Injection pressure | 120 | MPa | |
| Drying temperature | 120 to 140 | °C | |
| Drying time | 4.0 to 5.0 | hr | |
| Barrel 1 zone temperature | 250 to 280 | °C | |
| Barrel 2 zone temperature | 315 to 340 | °C | |
| Barrel 3 zone temperature | 315 to 340 | °C | |
| Nozzle temperature | 300 to 320 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |