| About |
|---|
| NHU-PPS Polymer is linear PPS resin with narrow molecular weight distribution, low content of oligomer, we use advanced automation controllable polymerization and post-processing technology, can provide different grades of products with MFR range from 50-3000.&& |
| Product Description | |
|---|---|
| Supplier | NHU |
| Generic | PPS |
| Material Status | Commercial: Active |
| Features | Weight distribution |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 316℃，5.0kg | 450 | g/10min | ISO 1133 |
| Chlorine Content | < 1200 | ppm | BS EN 14582 |
| Ash Content | |||
| 750℃ | 0.3 | % | ISO 3451 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Heating reduction | 0.10 | % | |
| volatility | 0.40 | % |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 165 | °C | |
| Drying time | 2.0 to 3.0 | hr | |
| Barrel rear temperature | 300 to 315 | °C | |
| Barrel middle temperature | 310 to 330 | °C | |
| Barrel front temperature | 315 to 330 | °C | |
| Nozzle temperature | 300 to 315 | °C | |
| Mold temperature | 130 to 150 | °C | |
| Back pressure | 4.00 to 5.00 | MPa | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |