| About |
|---|
| INVISTA’s Novadyn™ DT/DI is made from monomers DYTEK® A diamine, purified terephthalic acid (PTA) and purified isophthalic acid (PIA).&& |
| Product Description | |
|---|---|
| Supplier | INVISTA |
| Generic | HPPA |
| Material Status | Commercial: Active |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data |
|---|
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 260 | °C | |
| Barrel middle temperature | 275 | °C | |
| Barrel front temperature | 280 | °C | |
| Nozzle temperature | 285 | °C | |
| Mold temperature | 80 | °C | |
| Back pressure | 1.50 | MPa | |
| Screw speed | 100 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 270°C to 300°C |
| 3. 0.079 in/min |
| 4. 20°C/min |
| 5. Conditioned at 70°C, 62% RH |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |