Novalloy-S S1230

About
Novalloy-S S1230 Novalloy-S S1230 is a Polycarbonate + ABS (PC+ABS) product filled with 30% glass fiber. It can be processed by injection molding and is available in Europe.&&Novalloy-S S1230 Novalloy-S S1230 is a Polycarbonate + ABS (PC+ABS) material filled with 30% glass fiber. It is available in Asia Pacific. Primary attribute of Novalloy-S S1230: Flame Rated.&&

Product Description
Supplier	Daicel
Generic	PC+ABS
Material Status	Commercial: Active
Availabilitys	Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.36	g/cm³	ASTM D792
Shrinkage rate
MD	0.10 to 0.30	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	97.9	MPa	ASTM D638
Tensile strain
fracture	2.0	%	ASTM D638
Bending modulus	7450	MPa	ASTM D790
bending strength	137	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃，3.2mm	69	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	129	℃	ASTM D648
Linear coefficient of thermal expansion
MD	2.9E-5	1/℃	ASTM D696

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.