NuSil CV-2566

About
Controlled Volatility (CV) Silicone Materials Silicone’s ability to remain elastic at low temperatures and resistant to breakdown at high temperatures offer excellent utility in extraterrestrial environments where materials are repeatedly exposed to extreme temperatures. NuSil’s Controlled Volatility (CV) and Ultra Low Outgassing TM (SCV) silicone products are used by leading space programs to provide the much-needed resilient protection they require against contamination and material degradation. Benefits of Silicone Materials for Space Broad Operating Temperature Compensation for CTE Mismatch Protection Against Atomic Oxygen Optically Clear Formulations Flight Legacy Comments: Pourable RTV Cure, Primed Lap Shear 500 psi (3.4 MPa)&&

Product Description
SupplierNuSil
Generic硅酮
Material StatusCommercial: Active
FeaturesLow odor
AvailabilitysAfrica & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
Supplementary informationNominal valueUnitTest method
Cure SystemAlkoxy

Uncured PropertiesNominal valueUnitTest method
colourRed
Density1.49g/cm³
viscosity55Pa·s
Curing time
23℃1.7E+2hr
storage stability180min

Cured PropertiesNominal valueUnitTest method
Shore hardness
Shaw’s A55
lap shear strength3.45MPa
tensile strength6.55MPa
Tensile strain
fracture150%
tear strength7.01kN/m
Electrical strength32kV/mm

THERMALNominal valueUnitTest method
Linear coefficient of thermal expansion
MD3.3E-41/℃
Thermosetting components
Component A按重量计算的混合比: 100
Component B按重量计算的混合比: 0.50

Notes
1. Typical properties: these are not to be construed as specifications.
2. Primed with SP-120
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.