| About |
|---|
| Specially formulated nylon powder for the ROTOMOLDING process For uses where HIGH IMPACT properties are required Heat stabilized Dried to less than 0.20% moisture and packaged in foil-lined drums to eliminate the need for pre-drying Strongly recommend the use of an inert gas such as nitrogen in the mold to minimize thermal degradation during processing&& |
| Product Description | |
|---|---|
| Generic | PA6 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.10 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 1.5 to 2.0 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 23℃ | 53.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, 23 ℃ | 150 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 596 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 无断裂 | ASTM D256 | |
| Izod notched impact strength | |||
| 23℃，3.56 mm | 122 156 169 | J | ARM |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting peak temperature | 218 | ℃ | ASTM D3418 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |