Nylene® 7210 HS

About
Nylene 7210 HS has a filler/reinf consisting of 28% GF/MR.&&

Product Description
Generic	PA6
Material Status	Commercial: Active
Features	Good Rigidity,Good Dimensional Stability,Heat Stabilized
Availabilitys	North America
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.32	g/cm³	ASTM D792
Shrinkage rate
MD	0.80	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength
Fracture, 23 ℃	66.0	MPa	ASTM D638
Tensile strain
Fracture, 23 ℃	8.0	%	ASTM D638
Bending modulus
23℃	3390	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	78	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	151	℃	ASTM D648
Melting temperature	216	℃

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.