| About |
|---|
| NYLOY® KF-0020N 6231W is a Polyamide 6 (Nylon 6) material. It is available in Asia Pacific or North America. Primary attribute of NYLOY® KF-0020N 6231W: Flame Rated.&& |
| Product Description | |
|---|---|
| Supplier | Nytex |
| Generic | PA6 |
| Material Status | Commercial: Negative |
| Features | V-2 |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.55 | g/cm³ | ASTM D792 |
| Shrinkage rate | ASTM D955 | ||
| MD | 0.60 | % | ASTM D955 |
| TD | 0.40 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 77.5 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 1.2 | % | ASTM D638 |
| Bending modulus | 9810 | MPa | ASTM D790 |
| bending strength | 118 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃，3.2mm | 27 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 215 | ℃ | ASTM D648 |
| Thermal conductivity coefficient | ASTM E1461 | ||
| — | 1.3 | W/m/K | ASTM E1461 |
| — | 4.5 | W/m/K | ASTM E1461 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | > 1.0E+12 | ohms | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.60 mm | V-2 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Through-plane |
| 3. In-plane |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |