| About |
|---|
| OnFlex™ G7720 B is an easy processing, general purpose material designed for a wide variety of applications.&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 10 seconds, 23 ℃ | 58 | ASTM D2240 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 5.32 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 630 | % | ASTM D412 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.50 mm | HB | UL 94 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.16 | g/cm³ | ASTM D792 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 10.9 | Pa·s | ASTM D3835 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 171 to 199 | °C | |
| Barrel middle temperature | 182 to 216 | °C | |
| Barrel front temperature | 182 to 216 | °C | |
| Nozzle temperature | 193 to 227 | °C | |
| Mold temperature | 27 to 49 | °C | |
| Injection speed | 中等偏快 | ||
| Back pressure | 0.689 to 1.38 | MPa | |
| Screw speed | 25 to 100 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 3. 2 hr |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |