| About |
|---|
| OnFlex™ LO 7120-45N is an easy processing TPE designed for automotive applications requiring low VOC & Fogging performance Excellent surface finish Good adhesion to polypropylene Low odor VDA 270 Low FOG VDA 278 Low VOC VDA 278 Good compression set&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Low to No Fogging,Low odor |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 10 seconds | 45 | ISO 7619 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 4.50 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 700 | % | ISO 37 |
| Compression deformation | |||
| 23℃，72 hr | 21 | % | |
| 70℃，22 hr | 48 | % |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Common material types | 苯乙烯类热塑性弹性体 (TES) | ||
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.15 | g/cm³ | ISO 1183 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 7.90 | Pa·s | Internal Method |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 180 to 220 | °C | |
| Mold temperature | 30 to 60 | °C | |
| Injection speed | 中等偏快 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 1.15 g/cm³ ± 0.03 |
| 3. 45 Sh A ± 5 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |