OnFlex™ S KG 60A-3S2018

About
OnFlex™-S KG thermoplastic elastomer compounds are based on hydrogenated styrenic block copolymers. This range of compounds are specially compatabilized to provide excellent adhesion to polyamide polymers including PA6, PA6.6, PA11 and PA12. OnFlex™-S KG can be processed by 2K molding or overmolding, insert molding or co-extrusion. In addition to this, OnFlex™-S KG compounds are formulated to provide good processability and a good cost/performance ratio, a wide hardness range, good colourability and good mechanical properties.&&

About

OnFlex™-S KG thermoplastic elastomer compounds are based on hydrogenated styrenic block copolymers. This range of compounds are specially compatabilized to provide excellent adhesion to polyamide polymers including PA6, PA6.6, PA11 and PA12. OnFlex™-S KG can be processed by 2K molding or overmolding, insert molding or co-extrusion. In addition to this, OnFlex™-S KG compounds are formulated to provide good processability and a good cost/performance ratio, a wide hardness range, good colourability and good mechanical properties.&&

Product Description
Supplier	Polyone
Generic	TPE
Material Status	Commercial: Active
Features	Good bond
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Multiple injection molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.13	g/cm³	ISO 1183

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	60		ISO 868

elastic body	Nominal value	Unit	Test method
tensile strength
fracture	3.50	MPa	ISO 37
100% strain	2.20	MPa	ISO 37
Tensile strain
fracture	290	%	ISO 37
tear strength	21	kN/m	ISO 34-1
Compression deformation			ISO 815
23℃，72 hr	32	%	ISO 815
70℃，22 hr	62	%	ISO 815
100℃，22 hr	81	%	ISO 815

Supplementary information	Nominal value	Unit	Test method
Common material types	苯乙烯类热塑性弹性体 (TES

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	100	°C
Drying time	2.0	hr
Processing (melt) temperature	200 to 260	°C
Mold temperature	30 to 50	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.