Opticarb 8085MF20

About
Opticarb 8085MF20 is a Polycarbonate + ABS (PC+ABS) material filled with 20% mineral. It is available in North America for injection molding.&&

Product Description
Generic	PC+ABS
Material Status	Commercial: Active
Availabilitys	North America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.27	g/cm³	ASTM D792
Melt Flow Rate
260℃，2.16kg	15	g/10min	ASTM D1238
Shrinkage rate
MD：3.2 mm	0.30 to 0.50	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	65.0	MPa	ASTM D638
Tensile strain
fracture	10	%	ASTM D638
Bending modulus	2960	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	250	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed, 3.2 mm	125	℃	ASTM D648
Linear coefficient of thermal expansion
MD：-20~150℃	6.3E-7	1/℃	ASTM D696

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	90 to 110	°C
Drying time	3.0 to 4.0	hr
Recommended maximum moisture content	0.020	%
Barrel rear temperature	235 to 255	°C
Barrel middle temperature	245 to 260	°C
Barrel front temperature	260 to 270	°C
Processing (melt) temperature	260 to 280	°C
Mold temperature	50 to 80	°C
Injection pressure	50.0 to 100	MPa
Back pressure	0.300 to 0.703	MPa

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.