| About |
|---|
| Optix® CA-75 is a Polymethyl Methacrylate Acrylic material. It is available in Europe or North America. Typical application of Optix® CA-75: Automotive&& |
| Product Description | |
|---|---|
| Generic | PMMA |
| Material Status | Commercial: Active |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | 3.2 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 0.20 to 0.60 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 3650 | MPa | ASTM D638 |
| tensile strength | 71.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 4.2 | % | ASTM D638 |
| bending strength | 121 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 19 | J/m | ASTM D256 |
| Drop hammer impact | |||
| 3.2 mm | 0.226 | J | ASTM D5420 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 100 | ℃ | ASTM D648 |
| Vicat Softening Temp | 113 | ℃ | ASTM D1525 |
| Linear coefficient of thermal expansion | |||
| MD：-30~30℃ | 6.0E-5 | 1/℃ | ASTM D696 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Geometry GB |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |