Osterlene® HB3553Z

About
HB3553 is a high density polyethylene copolymer developed for blow molding applications. HB3553 is recommended for use in applications which require a combination of high top load strength and good environmental stress crack resistance (ESCR). Osterlene HB3553 meets the requirements of the Food and Drug Administration, 21 CFR Section 177.1520. This regulation allows the use of this olefin polymer in “…articles or components of articles intended for use in contact with food.” Specific limitations may apply. Contact your Osterman sales representative for more information.&&

About

HB3553 is a high density polyethylene copolymer developed for blow molding applications. HB3553 is recommended for use in applications which require a combination of high top load strength and good environmental stress crack resistance (ESCR). Osterlene HB3553 meets the requirements of the Food and Drug Administration, 21 CFR Section 177.1520. This regulation allows the use of this olefin polymer in “…articles or components of articles intended for use in contact with food.” Specific limitations may apply. Contact your Osterman sales representative for more information.&&

Product Description
Generic	HDPE
Material Status	Commercial: Active
Features	Good Rigidity,Copolymer,High ESCR
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.953	g/cm³	ASTM D4883
Melt Flow Rate
190℃，2.16kg	0.35	g/10min	ASTM D1238
ESCR(Environmental Stress Cracking Resistance)
F50	35.0	hr	ASTM D1693B
100% non-ionic detergent, F50	45.0	hr	ASTM D1693A

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	190	J/m	ASTM D256
Tensile impact strength	277	kJ/m²	ASTM D1822

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	73.9	℃	ASTM D648
Embrittlement temperature	< -75.0	℃	ASTM D746
Vicat Softening Temp	131	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	65		ASTM D2240
tensile strength
yield	27.6	MPa	ASTM D638
Tensile strain
fracture	> 700	%	ASTM D638
Bending modulus
tangent	1240	MPa	ASTM D790

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.