| About |
|---|
| LLM1416 is best suited for applications requiring excellent clarity, gloss, toughness and heat seal. Typical blown film applications include; seal layer in coextrustions, heavy duty packaging and clarity packaging. Osterlene LLM1416 meets the requirements of the Food and Drug Administration, 21 CFR Section 177.1520. This regulation allows the use of this olefin polymer in “…articles or components of articles intended for use in contact with food.” Specific limitations may apply. Contact your Osterman sales representative for more information.&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good Clarity,Good flexibility,Good surface appearance,Smoothness,High anti-blocking |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.916 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.4 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| friction coefficient | > 1.0 | ASTM D1894 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| Membrane puncture strength | 7.50 | J | ASTM D3763 |
| Membrane puncture force | 82.7 | N | ASTM D3763 |
| Secant modulus | ASTM D882 | ||
| 1% secant, MD | 152 | MPa | ASTM D882 |
| 1% secant, TD | 157 | MPa | ASTM D882 |
| tensile strength | ASTM D882 | ||
| MD, yield | 11.7 | MPa | ASTM D882 |
| TD, yield | 10.0 | MPa | ASTM D882 |
| MD, fracture | 69.6 | MPa | ASTM D882 |
| TD, fracture | 52.4 | MPa | ASTM D882 |
| Tensile strain | ASTM D882 | ||
| MD, fracture | 520 | % | ASTM D882 |
| TD, fracture | 600 | % | ASTM D882 |
| Elmandorf tear strength | ASTM D1922 | ||
| MD | 240 | g | ASTM D1922 |
| TD | 420 | g | ASTM D1922 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 60° | 130 | ASTM D2457 | |
| Haze | 4.0 | % | ASTM D1003 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Drop hammer impact | > 308.9 | kN/m | ASTM D1709 |
| Sealing Initial Temperature | 100 | ℃ | ASTM F88 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |