| About |
|---|
| 20％矿物填充PA66，优良的成型加工性能，一定的刚性，尺寸稳定、低翘曲 |
| Product Description | |
|---|---|
| Supplier | Polysyron |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Low warping,Excellent Processability,Good Dimensional Stability,Mineral filler |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Shrinkage rate | 0.8-1.0 | % | ISO 294-4 |
| Density | 1.30 | g/cm³ | ISO 1183-1 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa | ℃ | ISO 75-2 | |
| Flame retardant level | |||
| 1.60 mm | HB | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| bending strength | 120.3 | MPa | ISO 178 |
| Tensile strain | 2.5 | % | ISO 527 |
| tensile strength | 78 | MPa | ISO527 |
| Bending modulus | 6052 | MPa | ISO178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 3.4 | kJ/m² | ISO180 |
| Process Conditions | |||
|---|---|---|---|
| Typical processing conditions | Nominal value | Unit | Test method |
| Melt temperature | 250~280 | ℃ | |
| Temperature of the front section of the material barrel | 270~280 | ℃ | |
| Temperature in the middle section of the barrel | 260~270 | ℃ | |
| Temperature of the rear section of the barrel | 250~260 | ℃ | |
| Injection molding speed | 中速 | ||
| Dry conditions | 120℃，4h | ||
| Mold temperature | 80~120 | ℃ | |
| Back pressure | 5~10 | Mpa | |
| Processing upper limit temperature | 300 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |