| About |
|---|
| 机械性、耐久性、耐热性、吸水性、耐磨性、光泽性、着色性。 |
| Product Description | |
|---|---|
| Supplier | Nan Ya |
| Generic | polybutylene terephthalate |
| Material Status | Commercial: Active |
| Features | Low or no water absorption,Good Dimensional Stability,Solvent resistance,Good coloring,Heat Resistance, Good,V-0,Good Rigidity,Good surface appearance |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.40 | ASTM D792 | |
| Shrinkage rate | 1.8-2.0 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 58.8 | MPa | ASTM D638 |
| Bending modulus | 2744 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Nozzle temperature | 235 | ℃ | |
| Barrel temperature – front section | 240 | ℃ | |
| Barrel temperature – middle section | 240 | ℃ | |
| Barrel temperature – rear section | 245 | ℃ | |
| Mold temperature | 80 | ℃ | |
| Injection pressure | 30~40 | MPa | |
| Screw speed | 80 | rpm | |
| Injection speed | 最大 | ||
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |