| About |
|---|
| Product Description | |
|---|---|
| Supplier | Lubrizol Advanced Materials |
| Material Status | Commercial: Negative |
| Features | Soft,Good flexibility |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Specific Gravity | 1.19 | ASTM D792 | |
| Mold Shrinkage | 0.3-0.8 | % | ASTM D-955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | 75 | Shore | ASTM D224 |
| Tensile Modulus | |||
| 50% stretch elongation | 31 | MPa | ASTM D412 |
| 100% stretch elongation | 33.8 | MPa | ASTM D412 |
| Tensile Elongation | 350 | % | ASTM D412 |
| Tensile Strength | 46.9 | MPa | ASTM D412 |
| Tensile set | 70 | % | ASTM D412 |
| Tear strength | 228 | kN/m | ASTM D624 |
| Taber Abrasion | 65 | mg | ASTM D1044 |
| Flexural Modulus | 1516.8 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temperature | 55 | ℃ | ASTM D1525 |
| Glass Transition Temperature | 40 | ℃ | ASTM D3418 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion Molded | Nominal value | Unit | Test method |
| Injection Molding | Nominal value | Unit | Test method |
| Melt Temperature | 204-221 | ℃ | |
| Drying Temperature | 99-110 | ℃ | |
| Dew Point | -40 | ℃ | |
| Melt Temperature | 210-227 | ℃ | |
| Mold Temperature | 15-60 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |