| About |
|---|
| Normal viscosity, heat stabilised polyamide 4.6, 30% glass fiber reinforced, PTFE modified&& |
| Product Description | |
|---|---|
| Generic | PA 46 |
| Material Status | Commercial: Active |
| Features | Lubricating,Heat Stabilized |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data |
|---|
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 90 | °C | |
| Drying time | 4.0 | hr | |
| Recommended maximum moisture content | 0.070 to 0.15 | % | |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 295 to 320 | °C | |
| Barrel middle temperature | 305 to 330 | °C | |
| Barrel front temperature | 310 to 320 | °C | |
| Processing (melt) temperature | 305 to 325 | °C | |
| Mold temperature | 80 to 120 | °C | |
| Injection pressure | 85.0 | MPa | |
| Screw length to diameter ratio | 18.0:1.0 to 22.0:1.0 | ||
| Screw compression ratio | 2.2:1.0 to 2.8:1.0 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |