| About |
|---|
| 适用于注塑成型和挤出，光学，商业机器，包装，运动，电器，电器，照明，电线电缆，汽车，被单 |
| Product Description | |
|---|---|
| Supplier | Khouzestan |
| Generic | Polycarbonate |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 300℃，1.20kg | 7.1-10 | g/10min | ASTM D1238 |
| Density | |||
| 25℃ | 1.2 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | ≥60 | MPa | ASTM D638 |
| Elastic modulus | 2000-2400 | MPa | ASTMD-638 |
| Tensile strain | |||
| fracture | ≥85 | % | ASTM D638 |
| Dielectric strength | |||
| 50 Hz | ≥18 | Kv/mm | ASTM D149 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | |||
| B50 | 142-146 | ℃ | ASTM D1525 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Transmittance | |||
| 2 mm | ≥80 | % | ASTM D1003 |
| other | Nominal value | Unit | Test method |
|---|---|---|---|
| Solvent content | 最大值 1500 | ppm | GC |
| Yellow index | |||
| PC particles | 最大值 6 | ASTMD-1925 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ≥20 | kJ/m² | ASTM D6110 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Pre-drying | 120°C/4小时 | ||
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |