Pier One PC/ABS C1200 BK

About
Pier One PC/ABS C1200-BK is a Polycarbonate + ABS (PC+ABS) material. It is available in North America for injection molding.&&

Product Description
Generic	PC+ABS
Material Status	Commercial: Active
Availabilitys	North America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.12 to 1.20	g/cm³	ASTM D792
Melt Flow Rate
260℃，3.80kg	5.0 to 10	g/10min	ASTM D1238
Ash Content	0.0	%	ASTM D4218

MECHANICAL	Nominal value	Unit	Test method
tensile strength
23℃	48.3 to 68.9	MPa	ASTM D638
Tensile strain
Fracture, 23 ℃	> 30	%	ASTM D638
Bending modulus
23℃	1860 to 2550	MPa	ASTM D790
bending strength
23℃	62.1 to 96.5	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃，3.2mm	430 to 640	J/m	ASTM D256

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.