Plantic® GP100

About
Plantic Technologies Limited develops and produces advanced bio-based materials. Plantic® is an innovative product made from corn-starch (maize) that is Australian grown and non-genetically modified. Plantic® is an Australian registered trademark of Plantic Technologies Limited. Plantic® GP100 is a general purpose thermoplastic starch (TPS) polymer formulated for injection molding. It has been designed to be used in general applications with a wall thickness between 1.0 – 3.0 mm.&&

Product Description
Generic生物可降解聚合物
Material StatusCommercial: Active
FeaturesRenewable resources,Biodegradable,Food contact compliance
AvailabilitysAsia Pacific,Europe
Process MethodsInjection Molding

Technical Data
PHYSICALNominal valueUnitTest method
Density1.43g/cm³ASTM D792
Shrinkage rate
MD0.90 to 1.2%

IMPACTNominal valueUnitTest method
Impact strength of cantilever beam notch66J/mASTM D256

THERMALNominal valueUnitTest method
Hot deformation temperature
0.45 MPa, unannealed44.0ASTM D648
Vicat Softening Temp55.3ASTM D1525

MECHANICALNominal valueUnitTest method
Shore hardness
Shaw’s D54 ASTM D2240
Tensile modulus1200MPaASTM D638
tensile strength
yield< 42.0MPaASTM D638
Tensile strain
fracture110%ASTM D638

Process Conditions
injectionNominal valueUnitTest method
Drying temperature70°C
Drying time6.0 to 8.0hr
Recommended maximum moisture content2.0 to 3.0%
Barrel rear temperature110 to 150°C
Barrel middle temperature150 to 170°C
Barrel front temperature160 to 190°C
Nozzle temperature170 to 190°C
Processing (melt) temperature180 to 200°C
Mold temperature25 to 50°C
Back pressure0.00 to 10.0MPa
Screw speed50 to 150rpm

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.