| About |
|---|
| Plaskolite Acrylic PL-200 is a Polymethyl Methacrylate Acrylic material. It is available in North America for injection molding. Important attributes of Plaskolite Acrylic PL-200 are: Flame Rated Chemical Resistant Clarity Good Mold Release Good Toughness Typical application of Plaskolite Acrylic PL-200: Household Applications&& |
| Product Description | |
|---|---|
| Generic | PMMA |
| Material Status | Commercial: Active |
| Features | HB |
| Availabilitys | North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.18 | g/cm³ | ASTM D792 |
| Melt Flow Rate | 23 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 0.30 to 0.70 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 0.30 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 21 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 73.9 | ℃ | ASTM D648 |
| Melting temperature | 132 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | 7.2E-5 | 1/℃ | ASTM D696 |
| specific heat | 1460 | J/kg/℃ | ASTM C351 |
| Thermal conductivity coefficient | 0.20 | W/m/K | ASTM C177 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 18 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 60 Hz | 3.80 | ASTM D150 | |
| Dissipation factor | |||
| 60 Hz | 0.040 | ASTM D150 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | HB | UL 94 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Refractive index | 1.490 | ASTM D542 | |
| Transmittance | 92.0 | % | ASTM D1003 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| M-level | 84 | ASTM D785 | |
| Tensile modulus | 2620 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 60.0 | MPa | ASTM D638 |
| bending strength | |||
| yield | 103 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |