| About |
|---|
| PLEXIGLAS® 8H is an amorphous thermoplastic molding compound (PMMA). Typical properties of PLEXIGLAS® molding compounds are: good flow high mechanical strength, surface hardness and mar resistance high light transmission very good weather resistance free colorability due to crystal clarity. Special properties of PLEXIGLAS® 8H molding compound are: optimum mechanical properties increased heat deflection temperature high melt strength AMECA listing. Application: Used for extruding optical and technical profiles and sheets. Examples: sheets, tubes, multi-skin sheets, coextrusion of window profiles and similar applications&& |
| Product Description | |
|---|---|
| Supplier | ROHM |
| Generic | PMMA |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good liquidity,Good Hardness,Good melt strength,High ESCR,Good coloring,HB |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.19 | g/cm³ | ISO 1183 |
| Melt Volume Rate | |||
| 230℃，3.8 kg | 0.800 | cm³/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 3300 | MPa | ISO 527-1-2 |
| tensile strength | |||
| fracture | 78.0 | MPa | ISO 527-2/5 |
| Tensile strain | |||
| fracture | 6.5 | % | ISO 527-2/5 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Unnotch Impact strength | |||
| 23℃ | 20 | kJ/m² | ISO 179/1eU |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | |||
| B50 | 108 | ℃ | ISO 306 |
| Linear coefficient of thermal expansion | |||
| MD：0~50℃ | 8.0E-5 | 1/℃ | ISO 11359-2 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | B2 | DIN 4102 | |
| 1.60 mm | HB | UL 94 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Refractive index | 1.490 | ISO 489 | |
| Transmittance | 92.0 | % | ISO 13468-2 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | < 98.0 | °C | |
| Drying time | 2.0 to 3.0 | hr | |
| Melt temperature | 220 to 260 | °C | |
| Nozzle temperature | 220 to 260 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. D65 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |