| About |
|---|
| Polifil® Nylon 627是一种聚酰胺66（尼龙66）产品,。 它,在北美洲有供货。 典型应用领域为:房屋。&& |
| Product Description | |
|---|---|
| Generic | PA66 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.07 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 1.6 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 1.3 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 960 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ASTM D648 | ||
| 0.45 MPa, unannealed | 193 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 60.0 | ℃ | ASTM D648 |
| Melting temperature | 249 | ℃ |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+14 | ohms·cm | ASTM D257 |
| Dielectric constant | |||
| 1 MHz | 3.30 | ASTM D150 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 113 | ASTM D785 | |
| tensile strength | |||
| fracture | 44.8 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 55 | % | ASTM D638 |
| Bending modulus | 1520 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 293 | °C | |
| Barrel middle temperature | 279 | °C | |
| Barrel front temperature | 274 | °C | |
| Nozzle temperature | 260 to 299 | °C | |
| Processing (melt) temperature | 288 to 293 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |