POLYCOMPO PE SP3010

About
POLYCOMPO PE SP3010 is a Linear Low Density Polyethylene product. It can be processed by blown film and is available in Asia Pacific. Typical application: Bags/Liners. Primary characteristic: rigid.&&

Product Description
Supplier	POLYCOMPO
Generic	Linear low density polyethylene
Material Status	Commercial: Active
Features	Good Rigidity
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.926	g/cm³	ISO 1183
Melt Flow Rate	0.80	g/10min	ISO 1133
ESCR(Environmental Stress Cracking Resistance)
Compression Molding	1000	hr	ASTM D1693

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength	无断裂		ISO 179

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	106	℃	ASTM D1525 , ISO 306
Crystallization peak temperature
DSC	124	℃	ASTM D3418 , ISO 3146

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D, molded	54		ASTM D2240 , ISO 868
tensile strength			ISO 527-2
Yield, molding	13.0	MPa	ISO 527-2
Fracture, molded	25.0	MPa	ISO 527-2
Tensile strain
Fracture, molded	500	%	ISO 527-2
Bending modulus
Compression Molding	490	MPa	ISO 178

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.