| About |
|---|
| POLYCOMPO PP J702LB is a Polypropylene product. It can be processed by injection molding and is available in Asia Pacific. Primary characteristic: weather resistant.&& |
| Product Description | |
|---|---|
| Supplier | POLYCOMPO |
| Generic | PP not specified |
| Material Status | Commercial: Active |
| Features | Weather resistance is good |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.910 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 1.8 | g/10min | ISO 1133 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179 | ||
| -20℃ | 7.0 | kJ/m² | ISO 179 |
| 23℃ | 60 | kJ/m² | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 90.0 | ℃ | ISO 75-2/B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 75 | ISO 2039-2 | |
| Tensile modulus | 1200 | MPa | ISO 527-2 |
| tensile strength | |||
| yield | 25.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 200 | % | ISO 527-2 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |