POLYFLON™ F-208

About
POLYFLON™ F-208 Daikin PTFE (polytetrafluoroethylene) fine powders are soft, white polymers that are produced from PTFE aqueous dispersions. These fine powders possess the lowest coefficient of friction, the highest heat resistance, chemical resistance, electrical properties, and non-sticking properties of all fluoropolymers. Daikin PTFE fine powders readily adsorb organic solvents resulting in the formation of a paste that can be easily extruded into thin, flexible sections.&&POLYFLON™ F-208 F-Series PTFE F-Series is called Fine Powder and can be used in paste extrusion molding by adding an oil for luburicant. It is suitable for thin-walled tubes, thin rods and wire coating. Features Suitable for thin tubes and wire coating with heat resistance.&&

About

POLYFLON™ F-208 Daikin PTFE (polytetrafluoroethylene) fine powders are soft, white polymers that are produced from PTFE aqueous dispersions. These fine powders possess the lowest coefficient of friction, the highest heat resistance, chemical resistance, electrical properties, and non-sticking properties of all fluoropolymers. Daikin PTFE fine powders readily adsorb organic solvents resulting in the formation of a paste that can be easily extruded into thin, flexible sections.&&POLYFLON™ F-208 F-Series PTFE F-Series is called Fine Powder and can be used in paste extrusion molding by adding an oil for luburicant. It is suitable for thin-walled tubes, thin rods and wire coating. Features Suitable for thin tubes and wire coating with heat resistance.&&

Product Description
Supplier	Daikin Fluorochemicals
Generic	PTFE
Material Status	Commercial: Active
Features	No viscosity,Good Clarity,Antifreeze,High Heat Resistance
Availabilitys	North America,Asia Pacific
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Apparent density	0.45	g/cm³	ASTM D4895
Average particle size	500	µm	ASTM D4895

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	> 19.6	MPa	ASTM D638
Tensile strain
fracture	> 350	%	JIS K6891

THERMAL	Nominal value	Unit	Test method
Melting peak temperature	322 to 328	℃	ASTM D4895

Electrical performance	Nominal value	Unit	Test method
Dielectric constant	2.10
Dissipation factor	1.9E-4

Supplementary information	Nominal value	Unit	Test method
Reduction Ratio	> 4000

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.