| About |
|---|
| POLYFLON PTFE M-series is a granular powder for compression molding. As melt viscosity is extremely high, it cannot be used for molding applied to general plastic. Therefore basically at first it is compressed in the mold and is fused by sintering over its melting point. Various molding methods are developed. There are many types of POLYFLON PTFE to be applied the methods, conditions in mold processing and application. Features Good flowability, small particle size, sharp particle size distribution and low electrostatic charging property. Suited for thin-walled mold gap and iso static molding because of the excellent filling property.&& |
| Product Description | |
|---|---|
| Supplier | Daikin Fluorochemicals |
| Generic | PTFE |
| Material Status | Commercial: Active |
| Features | High Viscosity,Good liquidity |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Apparent density | 0.86 | g/cm³ | |
| Average particle size | 400 | µm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |