| About |
|---|
| Polymer-E F1100 is a Low Density Polyethylene product. It can be processed by extrusion and is available in Asia Pacific. Typical application: Hose/Tubing. Primary characteristic: good processability.&& |
| Product Description | |
|---|---|
| Supplier | APC |
| Generic | LDPE |
| Material Status | Commercial: Negative |
| Features | Excellent Processability |
| Availabilitys | Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.921 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.1 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 50.0 | ℃ | ASTM D648 |
| Embrittlement temperature | < -70.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 96.0 | ℃ | ASTM D1525 |
| Melting temperature | 107 | ℃ | Internal Method |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 31.8 µ m, blow molded film | 66 | ASTM D523 | |
| Haze | |||
| 31.8 µ m, blow molded film | 11 | % | ASTM D1003 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 50 | ASTM D2240 | |
| friction coefficient | < 0.85 | ASTM D1894 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |