| About |
|---|
| A fractional melt low density polyethylene Applications: – Produce bags – Frozen foods and dry goods packaging Case shrink wrap, bundling Laminations General purpose clarity packaging Features: Excellent optics and impact strength High coefficient of friction Slip: zero Antiblock: 3000 ppm&& |
| Product Description | |
|---|---|
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | High Friction,High impact resistance,High anti-blocking,Low density |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.925 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.80 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| friction coefficient | 0.57 | ASTM D1894 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| Drop hammer impact | 110 | g | ASTM D1709 |
| Elmandorf tear strength | ASTM D1922 | ||
| MD | 230 | g | ASTM D1922 |
| TD | 200 | g | ASTM D1922 |
| Oxygen transfer rate | 5900 | cm³/m²/24 hr | ASTM D3985 |
| Water vapor transmittance | 17 | g/m²/24 hr | ASTM F1249 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 98.9 | ℃ | ASTM D1525 |
| Melting peak temperature | 112 | ℃ | ASTM D3418 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 60° | 127 | ASTM D2457 | |
| Haze | 5.0 | % | ASTM D1003 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |