| About |
|---|
| A blow molding grade high density polyethylene Applications: Injection blow molding Features: Zinc stearate Excellent stiffness Exceptional processability FDA 21 CFR 177.1520 (c) 3.1 & 3.2a&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Food contact compliance,High density |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.955 | g/cm³ | ASTM D792 |
| ESCR(Environmental Stress Cracking Resistance) | 35 | hr | ASTM D1693B |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.35 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 23℃ | 28 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 600 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 1450 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | <-75 | ℃ | ASTM D746 |
| Linear coefficient of thermal expansion |
| Notes |
|---|
| 1. Zinc stearate |
| 2. Typical properties: these are not to be construed as specifications. |
| 3. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |