| About |
|---|
| PRIMALLOY® B1700 is a Thermoplastic Elastomer (TPE) material. It is available in Asia Pacific, Europe, or North America. Primary attribute of PRIMALLOY® B1700: Low Hardness.&& |
| Product Description | |
|---|---|
| Supplier | Mitsubishi |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Low Hardness |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.970 | g/cm³ | ISO 1183 |
| Shrinkage rate | |||
| MD：2.0 mm | 0.90 | % | ISO 294-4 |
| TD：2.0 mm | 2.6 | % | ISO 294-4 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 0.50 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| 68 | ISO 7619 | ||
| tensile strength | 10.0 | MPa | ISO 37 |
| Tensile strain | 750 | % | ISO 37 |
| tear strength | 41 | kN/m | ISO 34-1 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 120x120x2 mm test plaque |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |