| About |
|---|
| Exceptional organoleptic properties and outstanding balance of stiffness, toughness and environmental stress cracking resistance make Purell ACP6541A the choice of customers for the production of closures for still mineral and sparkling water, CSD and many other types of food and non-food caps and closures as well as tube shoulders and compression moulding applications. Purell ACP 6541A is additionally used by our customers in injection moulding applications in the medical and pharmaceutical market after approval is given by LyondellBasell. Without exception, all potential activities for applications in the pharmaceutical, medical device, laboratory and diagnostics area have to be discussed with the relevant LyondellBasell Technical and Business contacts first.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Ethylene oxide disinfection,Good sensory characteristics.,Good flexibility,High liquidity,Good Rigidity,High density,High ESCR |
| Availabilitys | Africa & Middle East ,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.954 | g/cm³ | ISO 1183 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 1.5 | g/10min | ISO 1133 |
| 190℃，5.0kg | 6.4 | g/10min | ISO 1133 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 50 ℃，2% Arkopal | 30.0 | hr | Internal Method |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179 | ||
| -30℃ | 4.5 | kJ/m² | ISO 179 |
| 23℃ | 11 | kJ/m² | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temperature | |||
| B50 | 70.0 | ℃ | ISO 306 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D | 55 | ISO 868 | |
| Ball indentation hardness | |||
| H 132/30 | 54.0 | MPa | ISO 2039-1 |
| Tensile Modulus | 1100 | MPa | ISO 527-2 |
| Tensile Strength | |||
| 22.0 | MPa | ISO 527-2 | |
| Tensile Strain | |||
| 10 | % | ISO 527-2 |
| Process Conditions | |||
|---|---|---|---|
| Injection Molding | Nominal value | Unit | Test method |
| Melt Temperature | 190 to 230 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Full Notch Creep Test, 6 MPa |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |