Purell PE 3040 D

About
Purell PE 3040 D is a low density polyethylene with high rigidity and good chemical resistance. It is delivered in pellet form. The grade is used by our customers for small blow moulding including packaging of pharmaceuticals in blow fill seal technology and injection moulding for medical devices, closures and seals. Without exception, all potential activities for applications in the pharmaceutical, medical device, laboratory and diagnostics area have to be discussed with the relevant Technical (P & AD) and Business contacts first. To discuss a medical/pharmaceutical application please contact: your local Distributor or your local Basell contact.&&

About

Purell PE 3040 D is a low density polyethylene with high rigidity and good chemical resistance. It is delivered in pellet form. The grade is used by our customers for small blow moulding including packaging of pharmaceuticals in blow fill seal technology and injection moulding for medical devices, closures and seals. Without exception, all potential activities for applications in the pharmaceutical, medical device, laboratory and diagnostics area have to be discussed with the relevant Technical (P & AD) and Business contacts first. To discuss a medical/pharmaceutical application please contact: your local Distributor or your local Basell contact.&&

Product Description
Supplier	LyondellBasell
Generic	LDPE
Material Status	Commercial: Active
Features	Good Rigidity,Solvent resistance,Ethylene oxide disinfection
Availabilitys	Africa & Middle East ,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.928	g/cm³	ISO 1183
Apparent density	> 0.50	g/cm³	ISO 60
Melt Flow Rate
190℃，2.16kg	0.25	g/10min	ISO 1133
ESCR(Environmental Stress Cracking Resistance)	18.0	hr	ASTM D1693

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp
A50	102	℃	ISO 306/A50
Melting temperature
DSC	115	℃	ISO 3146

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	51		ISO 868
Tensile modulus
23℃	300	MPa	ISO 527-2
tensile strength
Yield, 23 ℃	13.0	MPa	ISO 527-2

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	170 to 220	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.