| About |
|---|
| PureTherm® 3007C Opaque is a rigid PVC film with transmission values below 10% in the critical ultraviolet 290 — 450 nm range, which is also available in specialty tint. It is designed to give good impact strength and heat distortion control. It is designed for the packaging of food and medical device products and is ideal for modified atmosphere applications This film meets all FDA (DMF-8668) requirements.&& |
| Product Description | |
|---|---|
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Good Rigidity,High impact resistance,Self-extinguishing |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.34 | g/cm³ | |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | 127 to 1020 | µm | |
| tensile strength | |||
| MD, yield | 50.0 | MPa | ASTM D882 |
| Oxygen permeability (wet) (23 ℃, 250 µ m, 100% RH) | 15.5 | cm³/m²/24 hr | ASTM F1927 |
| Water vapor permeability | 3.1 | g/m²/24 hr | ASTM E96 |
| Free contraction | -4.0 to 4.0 | % | ASTM D2732 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | 75 | ℃ | ASTM D1637 |
| Cold shock | Good |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Roll Width | < 106.70 | cm | |
| Temperature of hot forming mold | 100 to 175 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Thickness tolerance: ±10% |
| 3. at 10 mil at 38°C, 90% RH |
| 4. Roll width tolerance: ±1.5 mm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |