| About |
|---|
| 24FS040 is a film grade Low Density Polyethylene (LDPE) produced by high pressure tubular process. It can be extruded with considerable ease on any conventional LDPE extruder. The polymer has been blended with necessary additives during manufacture to obtain good surface slip and easy openability between two layers of the film.&& |
| Product Description | |
|---|---|
| Supplier | Reliance |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Smoothness,Food contact compliance |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.922 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 4.0 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D882 | ||
| MD, fracture, 40 µ m, blow molded film | 18.0 | MPa | ASTM D882 |
| TD, fracture, 40 µ m, blow molded film | 16.0 | MPa | ASTM D882 |
| Tensile strain | ASTM D882 | ||
| MD, fracture, 40 µ m, blow molded film | 250 | % | ASTM D882 |
| TD, fracture, 40 µ m, blow molded film | 400 | % | ASTM D882 |
| Drop hammer impact | |||
| 40 µ m, blow molded film | 80 | g | ASTM D1709-A |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |