REPRO PP RC3X - SOLIAO

About
Standard injection moulding&&

Product Description
Supplier	Rondo
Generic	PP not specified
Material Status	Commercial: Active
Features	HB
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.940	g/cm³	ISO 1183
Melt Flow Rate
230℃，2.16kg	12	g/10min	ISO 1133
Shrinkage rate			ISO 2577
TD	1.2 to 1.6	%	ISO 2577
MD	1.2 to 1.6	%	ISO 2577

MECHANICAL	Nominal value	Unit	Test method
Tensile strain
yield	8.0	%	ISO 527-2
Bending modulus
23℃	1100	MPa	ISO 178
bending strength	40.0	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength			ISO 179
-20℃	3.0	kJ/m²	ISO 179
23℃	8.0	kJ/m²	ISO 179

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
1.60 mm	HB		UL 94
Igniting temperature of the hot wire
2 mm	650	℃	IEC 60695-2-13

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	80	°C
Drying time	2.0 to 4.0	hr
Processing (melt) temperature	180 to 220	°C
Mold temperature	40 to 80	°C
Injection pressure	40.0 to 110	MPa

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.