ROTOLENE® 93050

About
Linear Medium Density Polyethylene Copolymer, with U.V. stabilizer. Colors: Natural & Several Colors USES: Polyethylene of maximum quality, for manufacture water tanks, containers, excellent for doing foamed internal layer in colors, given high whiteness, with a fine finished in the outer color layer and fine texture. Resin used as a base of compounds SEVERAL COLORS & ROTOFOAM in WHITE and CRISTALBLUE colors. This product have to contain all requirements of the U.S. Food and Drugs Administration, covering safe use of polyethylene articles for direct food contact. 21 CFR 177.1520.&&

About

Linear Medium Density Polyethylene Copolymer, with U.V. stabilizer. Colors: Natural & Several Colors USES: Polyethylene of maximum quality, for manufacture water tanks, containers, excellent for doing foamed internal layer in colors, given high whiteness, with a fine finished in the outer color layer and fine texture. Resin used as a base of compounds SEVERAL COLORS & ROTOFOAM in WHITE and CRISTALBLUE colors. This product have to contain all requirements of the U.S. Food and Drugs Administration, covering safe use of polyethylene articles for direct food contact. 21 CFR 177.1520.&&

Product Description
Generic	LMDPE
Material Status	Commercial: Active
Features	Weather resistance is good,Food contact compliance
Availabilitys	Latin America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.935	g/cm³	ASTM D1505
Shrinkage rate	0.33 to 0.39		ASTM D1895
Melt Flow Rate
190℃，2.16kg	5.2	g/10min	ASTM D1238
ESCR(Environmental Stress Cracking Resistance)			ASTM D1693
10% non-ionic detergent	300	hr
100% non-ionic detergent	> 1000	hr
Particle size
35 mesh		%	ASTM D1921

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	18.6	MPa	ASTM D638
Tensile strain
yield	12	%	ASTM D638
Bending modulus	689	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Low temperature shock
3.18 mm	200	J/m	ARM

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	50.0	℃	ASTM D648

Supplementary information	Nominal value	Unit	Test method
Pourability	1500.00 to 2400.00	g/10 min	ASTM D1895

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.