| About |
|---|
| Lubricated – Preliminary Datasheet |
| Product Description | |
|---|---|
| Generic | PA 6+PP |
| Material Status | Commercial: Active |
| Features | Lubricating |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.05 | g/cm³ | ISO 1183 |
| Shrinkage rate | |||
| MD：4.0 mm | 1.5 to 2.0 | % | ASTM D955 |
| Water absorption rate | |||
| 23℃，24hr | 0.20 | % | ISO 62 |
| water content | 0.20 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 2600 | MPa | ISO 527-2 |
| Tensile stress | 60.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| yield | > 10 | % | ISO 527-2 |
| Bending modulus | 2300 | MPa | ISO 178 |
| Bending stress | 80.0 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 7.0 | kJ/m² | ISO 180-1A |
| Notched impact strength of cantilever beam | 100 | kJ/m² | ISO 180/1U |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 8.0 MPa, unannealed | 60.0 | ℃ | ISO 75-2/C |
| Vicat Softening Temp | 147 | ℃ | ISO 306/B120 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Processing (melt) temperature | 232 to 260 | °C | |
| Mold temperature | 54 to 82 | °C | |
| Injection pressure | 69.0 to 103 | MPa | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |