RTP 399 X 147558 A

About
EMI/RFI/ESD Protection – X-Ray Detectable

Product Description
Generic	Polycarbonate
Material Status	Commercial: Active
Features	Electrostatic discharge protection,EMI,RFI
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.57	g/cm³	ASTM D792
water content	0.020	%

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	2960	MPa	ASTM D638
Tensile strength	62.7	MPa	ASTM D638
Tensile strain
yield	4.9	%	ASTM D638
Bending modulus	3100	MPa	ASTM D790
bending strength	105	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
3.2mm	43	J/m	ASTM D256
Notched impact strength of cantilever beam
3.2 mm	560	J/m	ASTM D4812

Electrical performance	Nominal value	Unit	Test method
Volume resistivity	< 1.0E+10	ohms·cm	ASTM D257

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	121	°C
Drying time	4.0	hr
Dew Point	-29	°C
Processing (melt) temperature	288 to 316	°C
Mold temperature	82 to 121	°C
Injection pressure	68.9 to 103	MPa

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.