SABIC® HDPE CC453SL

About
SABIC® HDPE CC453SL offers a good combination of stiffness, impact resistance, ESCR and organoleptic properties. The typical application of this grade is mainly injection moulding and compression moulding of caps for still water, slightly carbonated or pressurized drinks, juices or any other non-sparkling drinks. SABIC® HDPE CC453SL does contain slip agent for an easier opening. It is stabilised against UV light because the slip agent is sensitive to light; sunlight exposure should be avoided. This product is not intended for and must not be used in any pharmaceutical/medical applications.&&

About

SABIC® HDPE CC453SL offers a good combination of stiffness, impact resistance, ESCR and organoleptic properties. The typical application of this grade is mainly injection moulding and compression moulding of caps for still water, slightly carbonated or pressurized drinks, juices or any other non-sparkling drinks. SABIC® HDPE CC453SL does contain slip agent for an easier opening. It is stabilised against UV light because the slip agent is sensitive to light; sunlight exposure should be avoided. This product is not intended for and must not be used in any pharmaceutical/medical applications.&&

Product Description
Supplier	SABIC
Generic	HDPE
Material Status	Commercial: Active
Features	Good Rigidity,Weather resistance is good,High impact resistance,Smoothness,Good sensory characteristics.,High density,High ESCR
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.953	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	4.0	g/10min	ASTM D1238
ESCR(Environmental Stress Cracking Resistance)
100% non-ionic detergent, molded, F50	7.00	hr	ASTM D1693B

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
Injection molding	150	J/m	ASTM D256

Supplementary information	Nominal value	Unit	Test method
Sensoric（Organoleptic properties）	Approved		Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D, injection molding	60		ASTM D2240
tensile strength			ASTM D638
Yield, injection molding	23.0	MPa
Fracture, injection molding	21.0	MPa
Tensile strain
Fracture, injection molding	> 800	%	ASTM D638
Bending modulus
injection molding	800	MPa	ASTM D790
bending strength
injection molding	21.0	MPa	ASTM D790

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.