SABIC® HDPE M864SE

About
SABIC® HDPE M864SE is an UV stabilized, high density polyethylene injection moulding grade with a narrow molecular weight distribution. It is typically used for injection moulding applications where rigidity, toughness and warp resistance are required. Typical applications. SABIC® HDPE M864SE is typically used for the manufacture of injection moulded cases, crates, trays, industrial pails and other similar items. This product is not intended for and must not be used in any pharmaceutical/medical applications.&&

About

SABIC® HDPE M864SE is an UV stabilized, high density polyethylene injection moulding grade with a narrow molecular weight distribution. It is typically used for injection moulding applications where rigidity, toughness and warp resistance are required. Typical applications. SABIC® HDPE M864SE is typically used for the manufacture of injection moulded cases, crates, trays, industrial pails and other similar items. This product is not intended for and must not be used in any pharmaceutical/medical applications.&&

Product Description
Supplier	SABIC
Generic	HDPE
Material Status	Commercial: Active
Features	Weather resistance is good,Good flexibility,High elastic,Weight distribution,High density
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.964	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	8.0	g/10min	ISO 1133
190℃，5.0kg	22	g/10min	ISO 1133

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	95	℃	ISO 75-2/Bf
Melting temperature	135	℃	ISO 11357-3
Vicat Softening Temp
B50	129	℃	ISO 306

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	4	kJ/m²	ISO 180-1A

MECHANICAL	Nominal value	Unit	Test method
Shaw’s D-molding	65		ISO 868
tensile strength
23℃	32	MPa	ISO 527-2
Tensile strain
Fracture, 23 ℃	>200	%	ISO 527-2
Tensile modulus
23℃	1450	MPa	ISO 527-2
bending strength
23℃	32	MPa	ISO 178
Bending modulus
23℃	1700	MPa	ISO 178

Process Conditions
injection	Nominal value	Unit	Test method
Injection temperature
Rear barrel temperature	130	°C
Barrel front temperature	275	°C
Mold temperature	30-40	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.