| About |
|---|
| SABIC® LDPE 2004CX3 is an Ultra Melt Strength (UMS) grade typically used in foam applications. Application SABIC® LDPE 2004CX3 can be typically used for all types of foam, produced with chemical blowing agents or physical gases, X-linked and non X-linked. This product is not intended for and must not be used in any pharmaceutical/medical applications.&& |
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Smoothness,Foaming performance,High anti-blocking,Good melt strength,Low density |
| Availabilitys | Europe |
| Process Methods | Foam extrusion molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.921 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 4.6 | g/10min | ISO 1133 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 86.0 | ℃ | ISO 306/A |
| Melting temperature | |||
| DSC | 107 | ℃ | DIN 53765 |
| Crystallization peak temperature | |||
| DSC | 96.0 | ℃ | DIN 53765 |
| Fusion heat | 107 | J/g | DIN 53765 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 44 | ISO 868 | |
| Tensile modulus | 240 | MPa | Internal Method |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |