| About |
|---|
| HP20023 is an additive free low density polyethylene grade with high melt flow, offering good processability and capability to accept high pigment loading during compounding. |
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.923 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 20 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 10% non-ionic detergent, F50 | 2.00 | hr | |
| 100% non-ionic detergent, F50 | 6.00 | hr | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Notched impact strength of cantilever beam | 500 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 92.0 | ℃ | ASTM D1525 |
| Melting temperature | 112 | ℃ | Internal Method |
| Crystallization peak temperature | 98 | °C | ISO 11357-3 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 45 | ISO 868 | |
| Tensile modulus | |||
| 1% cut, injection molding | 225 | MPa | ASTM D638 |
| Tensile strength | |||
| Yield, injection molding | 8.00 | MPa | |
| Fracture, injection molding | 9.00 | MPa | |
| Tensile strain | |||
| Fracture, injection molding | 150 | % | ASTM D638 |
| Bending modulus | 175 | MPa | ASTM D790 |
| bending strength | 7.00 | MPa | ASTM D790 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |